quad 33 supressor capacitor value

Hi,

Would anyone know the apropriate value to used on the main switch
(volume & main switch) of the quad 33 preamp. I am replacing the on-
off & volume switch on such a unit . The part I am replacing has no
suppressor cap on it. I have a few 250 V small square film capacitors
(4700pF...up to 1 uF Siemen and RIFA @ 250V) on hand.

Thank you in advance
.

Relevant Pages

  • Re: Blackout switch matrix problem
    ... The 40 pin connector between the ... I'm working on a switch matrix problem on a Williams Blackout. ... The system 3 through 7 driver boards are basically the same with minor ... some jumper wires replacing resistors in the switch inputs) so pretty much no ...
    (rec.games.pinball)
  • Re: F-14 SIP resistor network? or transistor?or faulty diode or short in the white/brown wire st
    ... I think I would be replacing them just for the sake ... So I seperated that switch under the sling ... Every time one of the other switches tilts the machine, ... from the right flasher on the row of back flashers, ...
    (rec.games.pinball)
  • Re: F-14 SIP resistor network? or transistor?or faulty diode or short in the white/brown wire st
    ... I think I would be replacing them just for the sake ... So I seperated that switch under the sling ... Every time one of the other switches tilts the machine, ... Look for either a diode shorted to a coil or switch frame or a bent switch ...
    (rec.games.pinball)
  • Re: Tech needed on TZ
    ... Too many times I see people just start "shotgun replacing" parts ... that all the optos are on that column 8. ... then do a test on the MPU board to see if the switch ...
    (rec.games.pinball)
  • Re: Hardware Problem?
    ... Just read your post about replacing the mobo--congratulations! ... |>switch was continuously depressed. ... Try unplugging the reset switch from ... |>pins which the power switch plugs into. ...
    (microsoft.public.windowsxp.basics)