Re: de-solder part side or underside


<antonlamont45@xxxxxxxxx> wrote in message
news:1136576709.790727.51130@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
> when removing a part from a circut board, should i heat the part side
> or the underside? i am guessing the underside since thats where you're
> supposed to solder just wanted to make sure.
>
> also, when the part is removed should i be removing the existing solder
> before soldering a new part on?

If you need to ask DON'T DO IT.

It rather depends on what type of component or PCB it is. You need
specialised tools, or certainly better tools than you are likely to have if
you need to ask.

geoff




.

Relevant Pages

  • de-solder part side or underside
    ... i am guessing the underside since thats where you're ... supposed to solder just wanted to make sure. ... when the part is removed should i be removing the existing solder ...
    (rec.audio.tech)
  • Re: de-solder part side or underside
    ... i am guessing the underside since thats where you're ... you almost always melt the solder from the bottom side and grip the ... the component side solder joint too, ... when the part is removed should i be removing the existing solder ...
    (rec.audio.tech)
  • Re: de-solder part side or underside
    ... > when removing a part from a circut board, ... If that's where its easiest to melt the solder, ... > i am guessing the underside since thats where you're supposed to solder ...
    (rec.audio.tech)
  • Re: replace caps on motherboard issue
    ... Another factor in removing ... those leads is the quality of the soldering iron. ... of the solder joint - becomes larger. ... > that these boards are at least 4 layers, with the caps soldered to ...
    (sci.electronics.basics)
  • Re: Checking Coax Connextion
    ... Removing the plating inside the hole will promote the flow of solder across the junction of connector body to shield, ... If you do what I suggested, there is no point in removing the plating from the inside wall of the hole first, because you're going to file all of that metal away. ...
    (rec.radio.amateur.antenna)