Re: Behringer Eurodexk MX3282 fader problem


"Eeyore" <rabbitsfriendsandrelations@xxxxxxxxxxx> wrote in message
news:484183E2.33DDD647@xxxxxxxxxxxxxx


gareth magennis wrote:

Now, I am not sure whether I have actually seen this happen on a
Behringer
any more, you know how it is when you start doubting yourself, but for
this
to occurr the fader must be bolted to the mixers front panel.

To be honest, I have never seen Behringer bolt any fader to the front
panel. It
would cost too much ( 2 screws) and add costly assembly time.

Maybe they do it on the DJ gear ?


Graham



I really can't remember which specific manufacturers do this, but yes, a lot
of DJ mixers seem to use screws. As I think do the Soundcraft Sprit Folio
range? The spare I have does not have the big solder tags on the housing
bottom that Behringer use to secure it to the PCB, so is a screw mount
variant from, I'm sure, the same company. I'm fairly but not fully
confident it is for a Vestax, which are quite well made actually.



Gareth.


.

Relevant Pages

  • Re: Behringer Eurodexk MX3282 fader problem
    ... Behringer any more, you know how it is when you start doubting yourself, ... I have never seen Behringer bolt any fader to the front ... It would cost too much (2 screws) and add costly assembly time. ... attached pcb. ...
    (rec.audio.pro)
  • Re: Yamaha 01v Fader Repair?
    ... authorized repair center. ... it's not that hard to open it and replace a fader. ... Remove all the screws from the side where the rack rails sit as well ... F: Was ist ein Mathematiker? ...
    (rec.audio.pro)
  • Re: Yamaha 01v Fader Repair?
    ... painful, time consuming and often fruitless, unless you're an ... it's not that hard to open it and replace a fader. ... Remove all the screws from the side where the rack rails sit as well ...
    (rec.audio.pro)
  • Re: "Sticky Goo" Inside Remote
    ... Gareth Magennis wrote in message ... Screws aren't enough -- the back snaps together so tightly that, ... I irreparably damaged remote for a Toshiba ...
    (sci.electronics.repair)
  • Re: Behringer Eurodexk MX3282 fader problem
    ... gareth magennis wrote: ... the MX3282 does NOT screw the fader to the front panel. ...
    (rec.audio.pro)