Getting rid of A800's

I need to get rid of a couple of Studer A800 Mk.3's that are 'in the
way'.
Transport is ok, audio electronics are ok but connectors can require a
fair bit of TLC/cleaning to coax all 24 tracks into life. Head wear is
quite high and a meter has been nabbed off one machine to fix the
other. They're currently based in London, UK.
Note that there is no hard sell here and I want to spend as little
time as possible dealing with them, so no timewasters please!

Cheers
Steve

-
steve AT steveevans DOT org
-
.

Relevant Pages

  • Re: Leevers Rich E200 up for grabs
    ... Not the finest analogue tape machine around - an A77 would ... For 'important' recordings the BBC used Studer at ... doubt any decent recording studio ever bought one - they were built down ... Only when the A810 came along could they match its transport for this type ...
    (uk.rec.audio)
  • Re: TECH: BK activating all flippers on power-up
    ... before the transport), but after transporting it and setting it up, ... all the flippers activate when it's powered up (along with a nasty hum ... Check to make sure you didn't mix up the connectors in the head, the large connectors that can be swapped. ... I hope that's not it because the flippers locking on happens to be a symptom of doing this, and it's not good for the game stuff gets damaged. ...
    (rec.games.pinball)
  • Re: Tech: Firepower 2 Bell ringing on power up
    ... during transport. ... transporting the game did you remove any of the connectors in the head ... been two connectors that are NOT dummy proof. ... be one white set and one black set but the factory often didn't pair ...
    (rec.games.pinball)