Re: Balanced, Unbalanced??

On Tue, 11 Oct 2005 22:06:22 GMT, Bob Quintal <rquintal@xxxxxxxxxxxx>
wrote:

> this BS!

#1

>You can drive a balanced line
>between a transformer that has no center tap to ground and a
>second transformer that has no center tap to ground. You cannot
>measure a polarity in this case,

#2

> but the phase relationship
>between the signals coming from the two wires is 180degrees
>different.

#3

>You obviously have no clue how transformers work. It is right
>for every transformer.

#4

>> Isn;t this all in the FAQ?

Yes; start there. Good fortune;
You're down four strikes, Mon.

Chris Hornbeck
.

Relevant Pages

  • Re: Reducing AC Filament Hum On A 5W SE
    ... the heater coils centre tap. ... Would a 2W dropping resistor with a 0.6W, metal film, ... you can figure out how to keep that cell phone transformer ...
    (alt.guitar.amps)
  • Re: 1 KVA 240 v transformer output 6v,8v,12 v AC how to test if it can supply 83 amps?
    ... transformer saturation surge currents at initial power up. ... AC tap) with the capacitive filter, the effective heating in the transformer ... secondary will be more than what a 6V 75A RMS AC load would produce. ...
    (sci.electronics.basics)
  • Re: 3 phase transformer connections?
    ... transformer. ... tap 4 on the first winding connected to tap 2 on the second winding; ... tap 4 on the third winding connected to tap 2 on the first winding. ... If you don't have a megger, use line voltage. ...
    (rec.crafts.metalworking)
  • Re: 3 phase transformer connections?
    ... transformer. ... tap 4 on the first winding connected to tap 2 on the second winding; ... tap 4 on the third winding connected to tap 2 on the first winding. ...
    (rec.crafts.metalworking)
  • Re: Rotory Impedence switch wiring diagram
    ... Since you know the maker of the transformer, ... contact them for the colour code. ... For the secondary, I'm sure Hammond uses ... The tap with the most amount of henries will ...
    (alt.guitar.amps)
Loading