Re: Where to put effects unit
- From: "Mike Rivers" <mrivers@xxxxxxxxxxx>
- Date: 5 Oct 2005 15:19:09 -0700
Rationem wrote:
> SR24·4 VLZ PRO 24x4 bus mixing console
>
> How would you set this up exactly? Like what goes to the effects unit
> and where does the mic plug in and such.
If you don't have the manual for your console, go here and downlaod a
copy:
http://www.mackie.com/pdf/archive/sr24-4_sr32-4_om.pdf
And if you already have the manual, shame on you for not reading it.
Mackie manuals are quite informative. Look on Page 15. You'll see the
two ways in which an effect processor is connected to a mixer.
You'll notice that a microphone isn't shown. That's because most effect
processors don't have a microphone input. You'd connect the microphone
to one of the input channels and either use the "serial" connection if
you're going to use that processor only on that microphone, or the
"parallel" connection if you're going to use it with several
microphones.
> We are currently using some of the auxes for monitors... am I way off
> base here or what?
Only if you want to use the "parallel" connection and have used all
your aux sends for monitors and don't have one left for the effect
processor.
.
- References:
- Where to put effects unit
- From: Rationem
- Re: Where to put effects unit
- From: Michael R. Kesti
- Re: Where to put effects unit
- From: Rationem
- Re: Where to put effects unit
- From: Travis Garrison
- Re: Where to put effects unit
- From: Rationem
- Where to put effects unit
- Prev by Date: Re: Where to put effects unit
- Next by Date: Re: Where to put effects unit
- Previous by thread: Re: Where to put effects unit
- Next by thread: Re: Where to put effects unit
- Index(es):
Relevant Pages
|
