FA: Pair of Matched Carver Silver Nine t Monoblocks

For Auction:

A pair of Carver Silver Nine t (with Bob Carver's "tube
transfer function" feature) monoblock amplifiers, very
close to new condition, 550 watts EACH into 8 ohms,
900 watts EACH into 4 ohms (and will drive lower
impedences, too). No functional problems. Excellent
sound, gobs of power! Sold new for $2500 pair.
These amps are now on eBay (with pictures), at:
David Ruether


Relevant Pages

  • FS: Pair Carver Silver 9T Monoblocks - POWER!!!
    ... A pair of Carver Silver 9T monoblock amplifiers, ... close to new condition, 525 watts EACH into 8 ohms, ...
  • Re: 211 and 845 operating Ea/Ia bias points.
    ... could seem OK but it means Pda = 80 watts, ... Anyone here with actual experience of using either tube ... the fact is that the same load at the same Ea and Ia can be used ... It means that if the speaker coils suits 6 ohms, and 6 ohms is the load, ...
  • Re: head and cabinet questions
    ... "Impedance 8 Ohms". ... Can I plug in this cabinet a 100 Watts RMS 8 Ohms 2% THD head without ... Your solid state amp can deliver 100 Watts into a load of 8 ohms. ...
  • Re: looking for advice or information
    ... When I had amps from the seventies, the big thing was 'how many watts ... At 8 Ohms fewer "loudness units" get out of the amp, ... The bottom end ranges when pushed to smiley face parameters only suck out power, and rarely actually do anything for your sound, then you push the tops and it just gets noisey. ...
  • Re: Discussing audio amplifier design -- BJT, discrete
    ... to be about learning to design with BJTs. ... maximum the wattage into 8 ohms should be around 10 watts. ... doing things the way the big amps do, but it is not so big as to be outrageously expensive, for example you still use a relatively small power supply, heatsinks, and inexpensive transistors, and at the end you can use it with your PC and really blow those 320 watt PFPO speakers away. ...