FS: EICO 377 Sine and Square Wave Audio Oscillator, Factory Built, Near Mint



FS: EICO 377 Sine and Square Wave Audio Oscillator, Factory Built,
Near Mint

Picture at:
http://mywebpages.comcast.net/mnowlen/eico377.jpg

Description: An EICO Sine & Square Wave Audio Generator, Model 377,
ppears to be Factory Built, (Kits have a -K Suffix) fully tested and
excellent working and cosmetic condition. Also included is a copy of
the operating and service manual.

This EICO Model 377 is an audio sine and square wave generator
providing sine wave voltages throughout the frequency range of 20 to
200,000 c.p.s. and useful square wave voltages throughout the
frequency
range of 60 to 30,000 c.p.s. The entire frequency spectrum is covered
in four ranges, providing a long effective scale length for maximum
accuracy and readability. A linear 0 to 100 scale is also provided for
reference purposes.

Specifications:
Sine Wave Range: 20 - 200,000 c.p.s. in 4 bands; the dial can be read
directly on all ranges.

Band A: 20 - 200 c.p.s.
Band B: 200 - 2000 c.p.s.
Band C: 2000 - 20,000 c.p.s.
Band D: 20,000 - 200,000 c.p.s.

Square Wave Range: 60 - 30,000 c.p.s. Read on same scales as sine
waves.

Output Voltage: 1000 ohms - 10 volts - 1% max. distortion / 10,000
ohms and higher - 14 volts - 1% max. distortion / 500 ohms - 8 volts
- 1.5% max. distortion.

Tube Complement: 1 - 6X5, 1 - 6SJ7, 1 - 6SN7, 2 - 6K6 and 1 - 3S6, 3
watt lamp.

Dimensions: 11 1/8" Long, 7 1/8" High, 7 5/8" Deep.

$50
plus $15 shipping in Contiental US.

Paypal, Postal Money Order for Check with 10 day clear.

Pleas Email Replies. Thanks for looking,

Mike Nowlen
mnowlen@xxxxxxxxxxx



.



Relevant Pages

  • FS: EICO 377 Sine and Square Wave Audio Oscillator, Factory Built, Near Mint -p2
    ... An EICO Sine & Square Wave Audio Generator, Model 377, ...
    (rec.audio.marketplace)
  • Re: Dual sine wave generator with variable frequency and 90 degree phase difference
    ... the same frequency with 90 degree phase difference (sine and cosine). ... I need a variable frequency between 0.05 Hz and 10 Hz. ... square wave for integrating to the ramp. ...
    (sci.electronics.design)
  • Re: Dual sine wave generator with variable frequency and 90 degree phase difference
    ... the same frequency with 90 degree phase difference (sine and cosine).. ... I need a variable frequency between 0.05 Hz and 10 Hz. ... square wave for integrating to the ramp. ...
    (sci.electronics.design)
  • Re: square to sine
    ... I want to drive a coil using a sine wave.I used to use a 5th order filter from Maxim for the conversion of square wave(1khz which is generated by the PIC micro) to sine wave.But that filter works fine but it also needs 125khz to convert 1khz square wave into 1KHZ sine wave.So i used to generate 1KHZ and 125khz square wave from the pic and then feed these waves into the filter and then the output from the filter will be a pure 1KHZ sine wave which is then used to drive the coil in one of my applications.But now the problem is that this takes too much of the processor power .So i am looking for a an alternative solution or a circuit where i can feed my reference signal from the PICwhich theron converts the 1khz square wave into 1khz sine wave. ...
    (comp.robotics.misc)
  • FS: EICO 377 Sine and Square Wave Audio Oscillator, Factory Built, Near Mint
    ... An EICO Sine & Square Wave Audio Generator, Model 377, ...
    (rec.audio.marketplace)