Re: Old Rockford

On Nov 27, 1:19 pm, "Christopher \"Torroid\" Ott" <spamtrap at
ottelectronics dot com> wrote:
What kind of speakers?

<Hube...@xxxxxxxxx> wrote in message

news:c62fab52-54bb-4a21-b34d-ae8a05937917@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx

I have an old Rockford Fosgate Punch 75 watt. 2- channel amp. If i
have 4 speakers all of them the same ohms (4 ohms) how can i wire it
so that all four speakers get some decent wattage?

I actually only have 3 speakers right now but the first two are Sony X-
plod 5x7's and the other is an old Kicker 6.5, i plan on filling the
other hole with another 6.5 probably a kicker
.

Relevant Pages

  • Re: I keep blowing damn speakers! Why?
    ... Peavey cabinet is 4 ohms for the horns and 4 ohms for the 15. ... There are not horns, they are conventional 8" cone speakers, The fifty watt ... being driven hard enough to burn the voice coil. ...
    (alt.guitar.bass)
  • Re: Amplilfier wiring
    ... I was surprised to see the wire ... size to four of the speakers as small as it is. ... Woofer amplifier output: 160 watts, with 1.5 ohms impedance. ...
    (sci.electronics.misc)
  • Re: Amplilfier wiring
    ... I was surprised to see the wire ... size to four of the speakers as small as it is. ... Woofer amplifier output: 160 watts, with 1.5 ohms impedance. ...
    (sci.electronics.misc)
  • Re: Update on my Cabinet
    ... I have a 4 watt Lil Punch amp that I want to run through the cab. ... Looking at the two jacks on the back of the cab the RH one when used on its own will probably allow access to all 4 speakers at once, whereas when the LH one is used as well it will probably split the speakers into two pairs which can then be used with a stereo amp or with two leads into a single mono amp. ... If the overall impedance of the cab in 4x12 mono mode is 8 ohms, each individual speaker could be 8 ohms if each pair is wired in series to give a total of 16 ohms per pair and then the pairs being wired in parallel when in mono to arrive back at 8 ohms for all four speakers at once. ...
    (alt.guitar.amps)
  • Re: Tube Amp - Autoformer - Speakers
    ... I recently acquired 4-ohm speakers and re-wired my SE 45 amp to use the ... this autoformer and re-wiring the OPT impedance tap to 8 or 16 ohms? ...
    (rec.audio.tubes)