Old Rockford

From: "Huber55@xxxxxxxxx" <Huber55@xxxxxxxxx>
Date: Mon, 26 Nov 2007 23:15:08 -0800 (PST)

I have an old Rockford Fosgate Punch 75 watt. 2- channel amp. If i
have 4 speakers all of them the same ohms (4 ohms) how can i wire it
so that all four speakers get some decent wattage?
.

Follow-Ups:
- Re: Old Rockford
  - From: Christopher \"Torroid\" Ott

Prev by Date: Re: Sony CDX-C6850 CD Player - Disable Alarm?
Next by Date: Re: Sony CDX-C6850 CD Player - Disable Alarm?
Previous by thread: Sony CDX-C6850 CD Player - Disable Alarm?
Next by thread: Re: Old Rockford
Index(es):
- Date
- Thread

Relevant Pages

Re: paging system problem
... There was a 35 watt amplifier that was tripping out on page. ... speakers, the load should not be greater than that. ... disconnected them and they read 20, 16, and 5.5 ohms respectively. ...
(sci.electronics.repair)
paging system problem
... I'm working on a 70 volt system that has a great deal of speakers. ... There was a 35 watt amplifier that was tripping out on page. ... disconnected them and they read 20, 16, and 5.5 ohms respectively. ...
(sci.electronics.repair)
Re: I keep blowing damn speakers! Why?
... Peavey cabinet is 4 ohms for the horns and 4 ohms for the 15. ... There are not horns, they are conventional 8" cone speakers, The fifty watt ... being driven hard enough to burn the voice coil. ...
(alt.guitar.bass)
Re: Update on my Cabinet
... I have a 4 watt Lil Punch amp that I want to run through the cab. ... Looking at the two jacks on the back of the cab the RH one when used on its own will probably allow access to all 4 speakers at once, whereas when the LH one is used as well it will probably split the speakers into two pairs which can then be used with a stereo amp or with two leads into a single mono amp. ... If the overall impedance of the cab in 4x12 mono mode is 8 ohms, each individual speaker could be 8 ohms if each pair is wired in series to give a total of 16 ohms per pair and then the pairs being wired in parallel when in mono to arrive back at 8 ohms for all four speakers at once. ...
(alt.guitar.amps)
Re: phonograph to usp adapter
... If it's supposed to be 8 ohms, ... as the impedance at that part of the ... Sixteen-ohm speakers were almost as common as eight, and I seem to recall 3.2-ohm speakers from that period. ... So it was 18 months after iMic was announced until it shipped, 6 months to iron out the usb problems of some Mac users, and a further 18 months before it was ready to record directly from a cartridge. ...
(rec.audio.tech)