Carver amp question
- From: tim_witort@xxxxxxxxxxx (Tim Witort)
- Date: Wed, 27 Jun 2007 11:08:19 -0500
I've had a Carver 2090i amp sitting on the shelf for a few
years after using it in a prior install. It performed very
well for me, so I'm putting it into a new install. I no longer
have the manual for it and can't find anything on the web
about the amp. I want to bridge it to drive a single driver
subwoofer, but there is no switch marked "BRIDGE". The
closest thing is a swtich marked MONO. And the four speaker
terminals have the positive from one channel circled and the
negative from the other channel circled. I would assume that
these are the terminals that will be driven when bridged.
Anyone familiar with Carver amps and if my above assumptions
are correct?
-- TRW
_______________________________________
t i m . w i t o r t
_______________________________________
.
- Follow-Ups:
- Re: Carver amp question
- From: BigBob
- Re: Carver amp question
- From: D.Kreft
- Re: Carver amp question
- Prev by Date: Re: Installing aftermarket deck
- Next by Date: Re: HOW TO WIRE CAR SUBS/AMP
- Previous by thread: Dynaxorb - back speaker distortion cure?
- Next by thread: Re: Carver amp question
- Index(es):
Relevant Pages
|