Re: Vegetable oil a good fish-safe lubrication?
- From: "Daniel Morrow" <videoman@xxxxxxxxxxxx>
- Date: Sun, 28 Aug 2005 17:33:42 -0700
"Logic316" <Logic316@xxxxxxxxxxxxxxx> wrote in message
news:GIqQe.28133$U63.1128@xxxxxxxxxxx
> Daniel Morrow wrote:
> > You might have read one of my previous posts saying I put my penguin
> > bio-wheel power filter in my big tank. Well the first time I tried it it
> > wouldn't do anything. So I checked the impeller and sure enough it had
> > seized (froze) because I hadn't used it for a long time and so the
impeller
> > wheel wouldn't move around the rod connected to the end caps. I soaked
the
> > impeller assembly in vegetable oil (Crisco brand vegetable oil, only
> > ingredient was soybean oil) and kept moving the impeller and it lossened
up
> > and began moving freely around the rod/stem.
>
>
> You might get away with it if the oil gets washed out, but I would
> *never* ever use a cooking oil as a mechanical lubricant. I've done it
> before with very bad results. Unlike WD-40, motor oil, and other
> mineral-based oils, they can slowly harden like a varnish and then
> gunk-up and completely clog a motor. I would try using pure mineral oil
> which you can buy at any pharmacy. It's petroleum-based like motor oil,
> but it has no toxic additives so you can even drink it (it's usually
> prescribed to treat constipation). There is also such a thing as
> "food-grade" silicone spray, certified non-toxic by the FDA to be OK to
> use on food processing equipment. You can also use Jojoba oil, which is
> an excellent natural and non-toxic plant oil often used to lubricate
> fine machinery such as wristwatches.
>
> - Logic316
>
>
>
> "Why *not* go to war just for oil?"
> -- Ann Coulter
I don't know about Ann coulter (;-) just joking around!) but thanks for the
information, I will use those alternatives in the future. I did rinse off
the impeller assembly after the lubricating too netmax - Thanks to netmax as
well for his information. I am wary of petroleum products even if they're
edible as I have had the experience in the distant past of them eating
plastic, but maybe edible petroleum products don't do that, I just don't
know. Common sense told me I could definitely lubricate this impeller
assembly and with this vegetable oil and use it without harming organisms
like my fish and plants. I have known about vegetable oil hardening in the
past when I was really young and trimming our dog's hair with oster clippers
I lubricated the clippers with vegetable oil as I was sorely lacking
appropriate oil and funds (12-13 years old, school, no job in site until 16
when I could legally get a work permit, etc.), the vegetable oil would dry
up fast (after days or a week or two) and the clippers would seize and I
would have to put more on and really jimmy it into working again - that
isn't exactly describing a varnish condition but I believe you for sure
logic316. I will probably use the edible silicone sprays in the future for
these things. Thanks, later!
.
- Follow-Ups:
- Re: Vegetable oil a good fish-safe lubrication?
- From: Logic316
- Re: Vegetable oil a good fish-safe lubrication?
- References:
- Vegetable oil a good fish-safe lubrication?
- From: Daniel Morrow
- Re: Vegetable oil a good fish-safe lubrication?
- From: Logic316
- Vegetable oil a good fish-safe lubrication?
- Prev by Date: Re: Air pumps
- Next by Date: Re: Vegetable oil a good fish-safe lubrication?
- Previous by thread: Re: Vegetable oil a good fish-safe lubrication?
- Next by thread: Re: Vegetable oil a good fish-safe lubrication?
- Index(es):
Relevant Pages
|