Re: Ping Blinky
On 2008-10-27, Blinky the Shark wrote:
Adam Funk wrote:
http://www.newsfroup.net/haifisch/
Heh. :) Is that German? I can't see any logos.
Yes, the "D" in the bottom left part of the plate is the code for
Deutschland.
--
I spend almost as time figuring out what's wrong with my computer as
I do actually using it. Networked software, especially, requires
frequent updates and maintenance, all of which gets in the way of
doing routine work. (Stoll 1995)
.
Relevant Pages
- Re: Size of a tool (lathe!)
... round tools are held against the bottom groove by the screws, ... The Daimler HighTechReport I subscribe to in German is a great example ... The Saxons in "Anglo-Saxon" were north Germans whom the Britons ... Britons/Celts to retreat into Wales and Ireland and became the English ...
(rec.crafts.metalworking) - Re: Ping Qi-on: Tiller on Art Bell
... The top and bottom on the inside was covered by ... ran another wire from the top plate to the outside of the ... On the first wire I soldered a plate two-by-two inches, ...
(sci.physics) - Re: Garage door torsion spring relocation project (Status = Not going well)
... The torsion spring was upgraded from 0.243" to 0.250" wire gauge. ... The spring anchor plate was securely bolted to the angle iron. ... The angle iron could only be lag screwed at the very top & bottom! ...
(alt.home.repair) - Re: Blacking a Narrowboat ... Question ?
... plate, as I'm told that being away from the light and air there isn't the requirement ... Surely it's obvious that the main reason bottom plates of new ... boat is craned out on completion there isn't time to paint the ... growth etc in the darker water underneath. ...
(uk.rec.waterways) - Re: My new spreader beam plan (visited steel yard)
... of the plate, like such: ... Denny, I kind of agree that it would possibly provide more strength, ... You've got an unbraced, slender beam. ... Stress is greatest at top and bottom, the top being in tension and ...
(rec.crafts.metalworking) |
|
