Re: Where to store small items off-site



Just today I retrieved a firearm that was secured in this manner for a
friend.

Water had entered the container and the firearm was partially covered
with rust.

TMT

Did he use glue to seal the end not being opened? Also might use plumbers
tape to seal end that is being opened.


.

Relevant Pages

  • Re: Lumiquest Flash Atachments Sticky Gummy Velcro
    ... > I have attached Velcro tape to my flashes that came with various soft boxes ... > and bounce cards made by Lumiquest. ... This Velcro has unfortunately become ... > sticky and gummy and the glue gets all over my gear. ...
    (rec.photo.equipment.35mm)
  • Re: Picture frame making tutorial
    ... photographs of the profiles were excellent examples. ... I also notice that you have a pretty nice mitre fence. ... apply finish, remove the tape, THEN glue it up. ...
    (rec.woodworking)
  • Re: Dell Inspiron 1150
    ... the glue is brittle and can be "cracked" ... glue line with masking tape, and pound on the tape line with a handy ... Pound all the way around the case along the glue line. ... watch out for charged hi-v capacitors when you get ...
    (sci.electronics.repair)
  • Re: A little pickguard help please...
    ... lint to make tape "low tack". ... Just a comment to those suggesting glue. ... load, the direction of load, vibration frequency, the energy in the ...
    (rec.music.makers.guitar.acoustic)
  • Re: Russian balls.... again
    ... >> I ended up having to use tape as well as glue as the ones without tape ... imagine sacrificing a ball by cutting it into small strips. ... able to slide a strip into the ball (with a loop of thread or thin wire ...
    (rec.juggling)