Re: Metal/Galvanized Water Holding Tank leaks
Janet Baraclough wrote:
>
> The message <T8mjf.7326$N45.7238@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx>
> from <maxh@xxxxxxxxxxx> contains these words:
>
> > The tank is outside.
> > I live in the desert, sunshine everyday and temperatures reach 125F in
> > summer.
> > UV light might make the poly tanks brittle over time
> > or do I not have to worry about that?
>
> Give it a shelter or cover and you won't have to
>
> > What about repairing a hole in a poly tank, can it be done?
>
> Why/how would a polytank get a hole?
neighbor target practicing and not understanding the
energy contained in a 7.62X39 cartridge.
.
Relevant Pages
- OpenGL rendering problem
... element package ABAQUS and when I lauch its graphical environment ABAQUS/CAE, ... SubSection "Display" ...
(Debian-User) - Re: Crazy Clown Loaches
... convinced is stuck in the wood. ... the hole through so next time they can just swim straight through. ... much larger tank than I had orignally wanted/ bought just so I could ... Loaches will put themselves in positions they can't ...
(rec.aquaria.freshwater.misc) - Re: Crazy Clown Loaches
... the hole through so next time they can just swim straight through. ... much larger tank than I had orignally wanted/ bought just so I could ... Loaches will put themselves in positions they can't ... others I foolishly put straight into the community tank and I will swear they grew at least 1/2 inch plus within a week or so....they are out and about and very confident. ...
(rec.aquaria.freshwater.misc) - Re: sump conundrum
... You probably already have one in the hole. ... Plump your pipe to the bulkhead down to the sump. ... I was thinking of slowly adding sand to create a dsb but the sand has been so yuck since I set this tank up 6 months ago that I'm a bit nervous about it. ... Items glued in could also give structural support, and could compromise the integrity of the sump if removed. ...
(rec.aquaria.marine.reefs) - Re: How to swage a hole for welding in an aluminum fitting on a fuel tank?
... hole is machined leaving the swedged flange. ... The bung has a flat surface on one side which is supposed to be inside ... tank flush with the tank bottom. ...
(sci.engr.joining.welding) |
|
