Re: Intermittent No-Start Problems on B&W G3
- From: Madwen <invalid@xxxxxxxxxx>
- Date: Fri, 03 Mar 2006 14:16:22 -0600
In article <1141398782.397988.306850@xxxxxxxxxxxxxxxxxxxxxxxxxxxx>,
"RJBME" <rjbeier@xxxxxxxxx> wrote:
<brevity snip>
Any insight or comments as to some trouble shooting techniques would be
much appreciated. For example, can I remove the SCSI HD and controller
from the system, install an older 40GB IDE HD use the restore disk to
install 10.3.9 on it and try booting from it?
I can't answer that question. But tell me, does your computer do better
cold booting than soft booting?
Have you considered SCSI voodoo? Has the terminator gone bad perchance
and is it still set properly? Have you also disconnected and then
reconnected everything on the SCSI chain?
.
- References:
- Intermittent No-Start Problems on B&W G3
- From: RJBME
- Intermittent No-Start Problems on B&W G3
- Prev by Date: Re: ?10.4.5 email problem: Where are my X509 CA certs stored?
- Next by Date: Re: wireless access point recommendation
- Previous by thread: Intermittent No-Start Problems on B&W G3
- Next by thread: Assign shortcut keys to Applescripts?
- Index(es):
Relevant Pages
|
