Re: future powermac directions


Something like this looks like about the best hi-speed option
for large storage on a powermac.

http://store.yahoo.com/firmtek/sata1ven22.html

A bit pricey, but includes 64-bit controller, cables,
enclosures, you name it and supports OS X.


.

Relevant Pages

  • Summary : SCSI Bus Transition
    ... Basically, cables were ok, and it was a combination of two ... As Brad said, the controller... ... condensation on the back of the server... ... Subject: *SCSI Bus Transition* ...
    (SunManagers)
  • RAID0 setup on FC3 (effect of IDE controllers and how to maximize throughput)
    ... A summary of my ide controller configuration is included below. ... 2-Assuming that drive speed is not the bottleneck, would drives on ide1 ... around with the cables for IDE0 and IDE1. ...
    (comp.os.linux.setup)
  • Re: MicroVAX II chiller theatre
    ... the controller is an RQDX3 module number M7555 ... 50 pin signal cable plugs into the ribbon connector that is under the J6 connector. ... You would plug the 2 cables into their respective ones for Fixed Disk 0. ...
    (comp.os.vms)
  • Re: Is Secondary IDE always slower than primary?
    ... I have seen board where the primary controller supported ... > Presuming it is not using a regular older IDE cable like the one the CD ... > swapping the cables onto the good machine. ... you have to actively try to destroy ...
    (RedHat)
  • Re: Uh-Oh..... Another foot story :-/
    ... Yes, it is pricey, and yes, insurance pays for all of it between the two ... something I have to keep in mind at all times, and my mind is not doing its ... :> doing it, but I accidentally leaned onto the controller, propelling it ... stop *before* they hit anything. ...
    (alt.support.diabetes)