Re: Burning smell



On Jul 8, 8:35 pm, rudaxter <rudaxter.2tg...@xxxxxxxxxxxxxxxx> wrote:
A couple of days ago i was on vacation and when i put a Memory stick pro
flash chip into my ZV6000's memory slot reader thing and while the
computer was trying to read the new drive i began to smell an electronic
burning smell followed by the screen flashing and then freezing. I held
the power button down to try to turn it off as quickly as possible but
that did nothing so i pulled the power cord and took the battery out to
turn of the computer. I then waited about 5 minutes and tried to turn
it back on expecting that nothing would happen but it started up just
like normal. I then checked to see if the computer recognized the flash
chip i had put in and it did so i proceeded to take the info off and
then back up all of my files onto my external hard drive in case the
laptop would not start again. Since then i have only started it once,
for about 5 minutes. Overall since the problem first took place the
computer has only been on for about 35 minutes. Finally, whenever the
computer is on i can smell the burnt electronics smell being expelled by
the fans so whatever was burning is either still burning when
electricity runs through it or there is just a lot of that smell in
there.

I was planning on taking the computer apart (i have done this
with laptops before) in order to do a visual inspection of the parts but
before i do that i was wondering whether or not anyone had any ideas
what the damaged part could be. Or what i should do.

conclusions:
-computer runs as it normally would-
-the memory chip reader didn't break because it can still read flash
chips
-the processor is still good (because the computer can run)
-i think the memory is good (the computer still says that i have 512mb
ram)
-both of the fans still work (i can feel the breeze out of the exhaust
ports)
-the hard drive still works (i can still access all of my files)

(the computer isn't overclocked)

Visual inspection is your best bet. If you can, strip it completely
down and closely examine all the parts.



If your computer still works, it must be a chip you don't use on a
regular basis. Or a burnt trace.


About the magic smoke: it does linger. But I'd consider it VERY
prudent to not use the computer until you at least ID the problem. As
there could be a short somewhere. Like a screw or metal piece.


.



Relevant Pages

  • Re: trimpot
    ... but do not understand all what is going on with the electronics. ... there is usually no way to identify the chip or its ... he can simply replace the rheostat with a fixed resistor. ... Getting resistors over 1M is not entirely trivial - they are readily ...
    (sci.electronics.design)
  • Re: trimpot
    ... but do not understand all what is going on with the electronics. ... have a 5 led random/sequencer flasher kit I purchased and built. ... look at the chip to see if you can see some kind of part number on it ... possibly part of the integrated circuit, which you wouldn't be able to ...
    (sci.electronics.design)
  • Re: OT: Any BCIT EET Grads Here?
    ... if the employee is or claims to be a member of a minority the hiring manager and the company can be in hot water rather soon. ... The deal is that a company that, say, has no electronics background just figures they're hiring you to do what they cannot: Design some electronics. ... But all this does not unfold until the actual chip design begins, when the first hard collision with a design rule comes along, and then another. ...
    (sci.electronics.design)
  • Re: deluxe reverb weak output
    ... And I distinctly smell something burning... ... chassis) its more likely the output transformer ... the reverb drive transformer burning. ...
    (alt.guitar.amps)
  • Re: OT: Any BCIT EET Grads Here?
    ... Why can't an employee be cut? ... The deal is that a company that, say, has no electronics background just ... Chip design is almost always like this. ...
    (sci.electronics.design)