Re: Laptop always dim at turn on



Hi jprice & welcome to HTFC
Well, sounds to me like the back lamps, they'er a wee bit like the ol'
flourescent tubes but they don't have no heater at the ends...they'er
called CCFL Cold Cathode Flouresecne Lamp, they'er about the
diameter of a knitting needle.

The voltage inverter is usually a modual, yes they do go sometimes,
unless you've got SMD soldering equipment the only thing you can do
is to replace it, they churn out about 2,000V or 2KV for short at
start-up.

The ones I've seen normally starts to lose the pure white emision, so
on white displays you start to get a pinkish tinge, then they start
the ol' flickering syndrome.... having said that bet I'll come across
a tube that does some other trick..!

The whole tube itself just slides out after disconnected it's wire
ended leads, there's usually one at the top and one at the bottom,
unless you are getting the exact replacement you need to be very
careful of the length and more so the diameter.

So chances if it went all at once I would suspect the inverter rather
than the tubes, thus it may be beneficial to change them both to
save time.

To give you some idea have a peep here-:
http://www.fonerbooks.com/laptop_5.htm

Davy

.



Relevant Pages

  • Re: BBC iPlayer petition
    ... The Philips SL lamps are good because when the tube fails you can take ... for the bathroom containing two PL7 tubes and it wasn't bright enough. ... I replaced it with a 2D Giotto which has only marginally higher power ... I was given some 20w "energy saving" lamps when I visited the local ...
    (comp.sys.acorn.misc)
  • Re: Possible to run fluorescent on lower current?
    ... fluorescent tubes to not go over the city ordinance for maximum light. ... making it hard to spread the light out uniformly from only two such lamps. ... some extra inductance in the ballast would give us less current. ... If you have a highly-decorated sign with lots of lettering, ...
    (sci.engr.lighting)
  • Re: Rewiring a ballast. Help needed.
    ... good 4' lamps, and rearrange the rest of the 8' to make that area look ... >> I am considering doing this mostly due to the high price of 8' tubes ... >> 1) Will I retain a similar amount of light from replacing those ... > that area to repair or replace the dead ones elsewhere. ...
    (sci.electronics.repair)
  • Re: Automotive HID Projector Lamp Exposing a PCB?
    ... Could I reduce the exp time with an auto HID projector lamp? ... UV tubes radiate radially. ... Anybody seen a spectral graph for those automotive HID lamps? ...
    (sci.electronics.design)
  • Re: Council Collection of Refuse
    ... I must say that I always assumed that these lamps used Neon. ... Flourescent tubes do contain an inert ... The mercury discharge itself generates a UV light and is not actually what ...
    (uk.legal)