Re: Dell Inspiron 8000 video won't fit screen




BTW, your inverter is model K021032.00, not 1031. That's what the
shorting jumpers set, look at the model sticker on the board and the
silk-screening next to RB.

If your laptop requires a model 1031 inverter then remove RB and short
RA.

zwsdot...@xxxxxxxxx wrote:
> milkman5241@xxxxxxxxx wrote:
> > I am not sure what to say, I don't see anything else that would be an
> > eeprom. I will take a pic of the entire thing. It is made by Ambit
> > model K021031.00
> >
> > http://www.afreeimagehost.com/upload/2201/dell_inspiron_problem_eeprom1.jpg
>
> Look at the sticker on the board. It says LTN150P2 - that is a Samsung
> 15" SXGA+, not SXGA LCD. Something on your inverter is configured for
> the wrong display size.
>
> Take a look at the old and new inverters and compare them in detail. I
> think you'd be best off looking at the three resistor spaces labeled
> RA, RB, RC since they look like configuration jumpers to me. The pic
> you showed me has RB shorted with a 0 ohm resistor and RA, RC open.
> Copy that configuration on your new inverter. See if the problem is
> fixed.

.



Relevant Pages

  • Re: Dell Inspiron 8000 video wont fit screen
    ... > eeprom. ... 15" SXGA+, not SXGA LCD. ... RA, RB, RC since they look like configuration jumpers to me. ... Copy that configuration on your new inverter. ...
    (comp.sys.laptops)
  • Re: Carte Blanche arrives!
    ... inverter against whatever output is driving the ready state LED: ... Can be routed to some FPGA pin and used to drive that inverter. ... Pins are tri-state before the configuration is done. ... re-establish it's slot/device acceleration configuration. ...
    (comp.sys.apple2)