Re: CD-ROM and Hard Drive on Same Cable

W. Watson wrote:
They are both powered up at once. There's no other way. I'm not sure how this helps detect whether the HD is alive. The CD drive has an LED, which turns on immeidately.

Next I would try taking the HD out of the carrier and attaching it
directly. You should also be able to hear/feel it spin up.

CJT wrote:

Watty wrote:


It's been awhile since I played hook up with drives. Here's my problem. I
have a CD-ROM drive at the end of a cable. It works fine. I thought I'd
stick a HD in as a slave. It doesn't get detected. I made it a slave.
However, I have no idea what the CD-ROM thinks it is--Ah, master according
to BIOS. It looks like it has two jumpers. (What are the jumper
possibilities for it?) It's a 56x Disc shown in BIOS as G6D M1.30. I'm
pretty sure the cables are 48-pin. The HD is a boot disk from an older
system, and is in a removable drive (handle on front). It seems seated and
I'm pretty confident it's powered up, although the removable container has
no LED. (I switched power with the CD-ROM to test it.)


Try powering both up at once.

Is it not

possible to
put a HD on the same cable with a CD-ROM?


It's possible.

The CD-ROM is on the end of it's cable. The connector at the end of the
cable has one (center) pin missing, so I can't put the HD in it.

I could put the HD on the same cable with my W2K boot-up HD, but the cable
positioning is a little weird. I'd need to re-arrange the position of the
removable drive a bit.






--
The e-mail address in our reply-to line is reversed in an attempt to
minimize spam. Our true address is of the form che...@xxxxxxxxxxxx
.

Relevant Pages

  • Re: system disk
    ... If after installing the cd-rom, if it's not listed in windows 98's My ... If it's an older cable, it may only have 2 plugs on it, ... Newer cables can have different colored plugs, ... You may also have trouble if the drives are not configured correctly. ...
    (microsoft.public.windowsxp.basics)
  • Re: Looking for a 95A chassis in EU
    ... Sometimes these cables have a surprising length. ... matter which end you plug into the PSU) ... Also haven't seen in Poland a genuine PS/2 mouse during the ... You might as well have the CD-ROM and its framing bezel. ...
    (comp.sys.ibm.ps2.hardware)
  • [OT?] CD-ROM and Hard Drive on Same Cable
    ... However, I have no idea what the CD-ROM thinks it is--Ah, master according to BIOS. ... It looks like it has two jumpers. ... I'm pretty sure the cables are 48-pin. ... I could put the HD on the same cable with my W2K boot-up HD, but the cable positioning is a little weird. ...
    (microsoft.public.win2000.general)
  • Re: CD-ROM and Hard Drive on Same Cable
    ... However, I have no idea what the CD-ROM thinks it is--Ah, master according ... It looks like it has two jumpers. ... pretty sure the cables are 48-pin. ... positioning is a little weird. ...
    (comp.sys.ibm.pc.hardware.systems)
  • Re: Setting up SATA HD and CD ROM - How to connect ide cable for CD-ROM
    ... I got my first SATA HD setup going. ... how should I connect the CD-ROM?. ... Is an SATA HD still considered primary master? ... 80-wire IDE cables. ...
    (alt.comp.hardware.pc-homebuilt)