Is Adaptec SATAConnect 1205SA hot swap compatible

I've got an Adaptec SATAConnect 1205SA PCI SATA controller and couple
of 300GB drive inside Promise SuperSwap 1100's enclosures with the
intention of using them as a low cost backup system.

For some reason I cannot hot swap the drives. The SuperSwaps are 100%
hot swap compatible but I'm not sure about the Adaptec controller.

Should I be able to hot swap with this controller with the drivers
provided (1.0.0.41)? If not, is there an updated driver or third party
driver I could use? Or do I need to get a different controller?

.

Relevant Pages

  • Re: Looking for SAS/SATA RAID Controller That Supports JBOD
    ... Right, which is why one speaks of a JBOD cabinet, not a JBOD drive. ... All refer to such a controller as a *RAID* controller supporting JBOD ar- ... -or- an external controller spanning drives in a cabinet. ...
    (comp.periphs.scsi)
  • Re: 3B2 Disks
    ... being able to read the disk in its present format. ... 2 MFM drives on a custom controller. ... SCSI came much later as an add on card. ...
    (comp.sys.3b1)
  • Re: How to play an old floppy disk.
    ... Here are the circuit diagrams for the FDD/HDD controller in the ... Therefore it has the same data rate and should be ... Are you sure there ever were drives for 40 tracks double sided? ... Specifies the size of the floppy disk to format. ...
    (comp.sys.ibm.pc.hardware.storage)
  • Re: 3B2 Disks
    ... 2 MFM drives on a custom controller. ... what it came out of) but the only SCSI I heard about on the 3B's used ... any software out and would more likely have recycled the floppy disks. ...
    (comp.sys.3b1)
  • Re: Model 4 Disk Drive Issue
    ... controller command could be changed to one that does write. ... remove media from all other drives. ... (If you have Tandon drives you will need to change the step rate*. ... each group is content of the floppy disk controller status register. ...
    (comp.sys.tandy)