Re: Accessing HD by bypassing BIOS?
- From: "Rod Speed" <rod_speed@xxxxxxxxx>
- Date: Sun, 11 Sep 2005 05:14:11 +1000
Here and Kickin' <carthell@xxxxxxxxx> wrote:
> My mom's Seagate ST38421A died after my sister's kids installed a
> game on her computer (I do not think the kids caused the problem,
> however.) The HD was factory installed into a Compaq 5441, and my
> attempt to diagnose the problem is the first time that anyone has
> touched the innards of the PC since it was assembled at the factory
> approximately six years ago.
> The symptoms are a strange singing sound as the computer starts up (my mom
> says that the sound was present for a time before the drive failed; the sound
> is NOT the BIOS beeping).
That is likely the drive recalibrating when it cant read the platters.
> After trying to boot from the HD, the CD-ROM, and the floopy disk. the
> computer announces a boot problem, and asks me to provide a system disk.
> The HD is the only device connected to the second IDE controller of
> the computer. The motherboard is a Gigabyte GA-5SMM.
> What I've done:
> -Booted from drive A: system runs MS-DOS fine, but declares a "Invalid drive
> specification" when I try to switch over to C:.
> -Tried to use Compaq's restore disk, but the system could not find the HD; the
> restore program asks me whether I want to restore again or exit the program.
> -Swapped the drive into my working Compaq 5204; no sound, but same error. Same
> difficulties with accessing C:
> -Tried to see whether the BIOS in my mom's computer has a HD
> diagnostic function; it doesn't. (Just a fuction that allows me to
> choose the boot device order. Fooling around with that didn't change
> the error message.) The BIOS is from Award; according to the chip's
> label, it is "PCI/PNP"-aware, and has a sticker that says "1.2B".
> -Spent two nights downloading Debian Linux, burned the image on a
> CD-R, and tried to boot off the CD; the same boot error message
> popped up.
> -Downloaded Seagate's OS-independent diagnostic tool, and it doen't
> work because the BIOS apparently can't see the HD. The program can
> talk to the HD controllers, however.
Then the drive has died and since its dead your PC too, it isnt something
basic like the ribbon cable, power or even the motherboard controller.
> -Finally, I popped off the jumper on the drive that changed the
> connection from "cable select" to "slave". Booted from drive A:. The HD still
> could not be found.
All that indicates that the drive had died,
particularly its invisible to the Seagate diagnostic.
> I cannot believe, aside from a possible mechanical problem that has
> caused a major malfunction/destruction of the HD's inner workings,
> that it is impossible to talk to the drive via software, somehow.
If the logic card fails, nothing will be able to see it.
> Does anyone have a suggested solution, or should I give up?
Since you're trying so hard, presumably the data hasnt been
backed up properly. It may be possible to get the data back
by swapping the logic card from a known good identical model.
.
- References:
- Accessing HD by bypassing BIOS?
- From: Here and Kickin'
- Accessing HD by bypassing BIOS?
- Prev by Date: Re: IBM and Identity Theft--Hard Drive
- Next by Date: Re: Toshiba 80GB notebook HDD problem
- Previous by thread: Re: Accessing HD by bypassing BIOS?
- Next by thread: inaccessable Sandisk Cruzer 512 USB stick
- Index(es):
Relevant Pages
|
Loading
