I installed MK and erable, but every time
I try to use any function from erable it says
"insufficient memory" and it shows that I have
8,808 Kb in port 0.
Is that 8,808 bytes free? (out of 128K non-merged RAM);
what does the MEM command return?
It would be no surprise for Erable (the CAS)
to need a lot of memory, and whatever portion
is in port 2 is "covered" (needs to be copied
into RAM to execute), IIRC.
Re: Feedback on a Linux Web Page please. ... Increasing the RAM on the little ...Intel 800 Series Chipset Motherboard ...Serial Port & 1 Parallel Port ...Onboard SoundMax Audio & NIC 10/100 ... (alt.os.linux)
Re: Octal switches: Maximising MCU pin usage with data busses ... >> their values when switching to the next switch 'chip'. ... >> of the chips, and say PORTB selecting the individual chips. ... Use one port as a bidirectional data buss, ... So the operation would be to set the RAM address, ... (comp.arch.embedded)
Re: dual ported RAM - different aspect ratio ... If the question is how to describe a port size ... could call 'a template'.... the RAM block) will be used by more then one ... with mismatched aspect ratio,... (comp.lang.vhdl)
Re: Total RAM ... around 240KB of RAM are available for HOME, Port 0 and working memory ... around 780KB of Flash ROM is available for user storage as Port 2 ... > Port 1 is actually flash even though it's named ERAM.... (comp.sys.hp48)
Re: Same error with all ports install! ... I have changed the RAM to diffrent 256 1 chipset DDR.... For whatever port!... The fault with bad capacitors is a well known quality control problem and if you search google for those terms, maybe you can get some more information as to what it is and why it occurs. ... (freebsd-questions)
