Re: Static screen C64

The wire in the fuse I'm currently using does look a bit suspicious in
the inside (deformed), but I can't distinguish whether it's open or
not. I checked the fuses' ratings and luckily they both say 1A / 250V.
Therefore I'm assuming it should be safe to swap them so I guess I'll
go ahead and see what happens. I'll post the results here when I'm
done.
.

Relevant Pages

  • Re: Making lightning with a thin wire
    ... (1/20,000th of a second darkening time) ... I worked in an on campus instrumentation lab. ... The fuse consisted of a piece of #30 wirewrap wire strung between two ...
    (sci.electronics.design)
  • Re: Making lightning with a thin wire
    ... (1/20,000th of a second darkening time) ... I worked in an on campus instrumentation lab. ... The fuse consisted of a piece of #30 wirewrap wire strung between two ...
    (sci.electronics.design)
  • Re: Battery drain update (Dodge Xplorer)
    ... light a "fridge failure" light if the switch cooled off. ... Fit it in place of the fuse. ... 500 ma would also be in the ballpark for a 12 volt relay or contactor coil. ... Tugging the wire leaving the fuse will ...
    (rec.outdoors.rv-travel)
  • Re: How much current safe for 30m extension?
    ... >It's always going to be safe, as it's got a fuse. ... I suppose you mean the wire won't melt. ... The job of the fuse is to protect the wire from ...
    (sci.electronics.equipment)
  • Re: How much current safe for 30m extension?
    ... >It's always going to be safe, as it's got a fuse. ... I suppose you mean the wire won't melt. ... The job of the fuse is to protect the wire from ...
    (sci.electronics.components)