Re: Experimental cartridge PCB for C64

I am not familiar with omegaQ, but a quick research on the web showed
me a size of some 50k bytes. This will not fit in this cartridge. Only
utilities up to 16k will fit. Further, you will need to have the ROM
image of the original cartridge. You cannot, and I repeat, cannot put a
tape or disk file (.d64) in a EPROM and run it. It requires some extra
startup codes etc.
There are over 20 different cartridge types. The one I am offering is
the simple Ultiboard type. With some modification of the board you
could expand to one or two others (needs in depth knowledge). You will
need the original ROM image, CRT images, as used in emulators, can
simply be transformed to the original format. I have programmed a PERL
program to do so.

Arjen

.

Relevant Pages

  • Re: Winchester Short Magnum Calibers
    ... I have a 270 WSM that I have just stocked using a CZ Model 3 barreled ... I have loaded is a couple of boxes of "sighters" with a powder load 1/2 ... That is that the cartridge is FAT!. ... It does not fit in any of my cartridge boxes! ...
    (rec.guns)
  • Re: rom cartridge for JET SET WILLY
    ... it would fit into a cartridge. ... You then are faced with writing a gzip decompresser that fits into the remaining 11 bytes. ... Unfortunately you still need to account for whatever bits of the ROM Jet Set Willy uses - presumably the character set, ...
    (comp.sys.sinclair)
  • Re: Ruger Single Six (Identifying Which Cylinder is .22 and which is .22 mag)
    ... larger cartridge will not fit in the smaller chamber but the smaller ... cartridge will fit in either. ... Heh heh. ...
    (rec.guns)
  • Re: Cynthcart v1.0 out now
    ... > Cartridge available from Atariage: ... "With a socket installed on the Cynthcart board, the board will NOT fit in ... the Retro Replay cartridge case doesn't properly fit in a brown ...
    (comp.sys.cbm)