Re: Apple IIc plus RGB video?

Jorge Chamorro Bieling wrote:
Simon D. Williams <email@xxxxxxx> wrote:


Found it!
http://www.ld8.org/LaserRGB/
The cable itself is DB15 M to DB9 F. About 3 inches from the DB15, the
passes through a pair of plastic rings and loops around twice. Maybe
tomorrow, if anyone is interested, I can trace the wires.


But, IIRC, the signals available at the video output connector of a
Laser128 are not equal to the (estrambotic) ones in a IIc. They are more
like the IIgs.

OK, I give up--what does "estrambotic" mean? ;-)

-michael

Music synthesis for 8-bit Apple II's!
Home page: http://members.aol.com/MJMahon/

"The wastebasket is our most important design
tool--and it is seriously underused."
.

Relevant Pages

  • Re: Apple IIc plus RGB video?
    ... passes through a pair of plastic rings and loops around twice. ... tomorrow, if anyone is interested, I can trace the wires. ...
    (comp.sys.apple2)
  • Re: Apple IIc plus RGB video?
    ... passes through a pair of plastic rings and loops around twice. ... tomorrow, if anyone is interested, I can trace the wires. ...
    (comp.sys.apple2)
  • Re: Todays what the heck is it? item...
    ... A friend of mine recently had to trace down a couple of short circuits ... breaker box between the two wires which were showing a shorted load. ... tone to figure out where the wires were running inside the drywall. ...
    (sci.electronics.repair)
  • Re: 10/100BaseT Impedance Mismatch
    ... the impedance is a function of the trace width, ... >> characteristic impedance. ... wires from the incoming Ethernet twisted pair wire to one of such ... This arrangement would give you 100 ohms differential ...
    (comp.dcom.lans.ethernet)
  • Re: Tech : Williams F-14 Tomcat System 11 gurus please chime in!
    ... I've spent a lot of time digging around the F-14 and a few other System 11's. ... This may take some time, but pull the CPU board off again, replace the confirmed toasted transistors, put the CPU board back on, but don't connect the coils to the board again. ... then forget the board and travel the wires. ... I bashed my head against chips, resistors, and displays trying to remedy problems with missing segments and I found one problem was a broken trace and the other was a corroded trace. ...
    (rec.games.pinball)