Re: Yet Another Zany SSC Issue

"Iosaef the Irascible" <josefcub@xxxxxxxxx> wrote in message
news:1138689339.089760.312610@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
>> Whatever the hell "PEBKAC" is supposed to mean...
>
>> People eating bananas kick amateur cameramen?
>
> Close... "Problem Exists Between Keyboard And Chair". An acronym
> defining an organic logic failure.
>
>> Is the Terminal/Printer block on the SSC set correctly? Seems to me I
>> recall that in the Printer setting, everythign goes out the door with
>> the high bit set.
>
> I've tried it set both ways, Terminal and Modem... Same symptoms both
> ways. I even made sure Communications Mode was enabled, per the
> manual.
>
> Heck, I even tried it set up in Printer mode, per the SSC manual and my
> IWII manual. Other than no longer echoing on the II's display, it
> exhibited the same issue...
>

Hi,

I have an SSC in a //e enhanced and I have not experienced this problem. I
have also used telix on the pc side. I have used both PR#2 and IN#2, but I
would use one of them, not both at the same time and I would only used them
if I was not using another software, like ADT or COMM.SYSTEM. I had another
problem where COMM.SYSTEM wouldn't receive, I had to enable interrupt with
the appropriate dip-switch. Except for the interrupt my dip-switch setting
comes out of the ADT documentation.

Knut


.