Re: Integer + Applesoft BASIC ROMs

Great Hierophant wrote:
If you used one switch, it would need to connect six inputs to +5v and ground all at once.

I think you may have misunderstood. You switch the single select line if you use different chips.

Where you use one large ROM chip to house two copies of different firmware, you switch the address lines as the rest of the chip remains active because it is the same chip.

Thankx,
Ed
.

Relevant Pages

  • Re: System6 Pop Bumber Woes
    ... replaced the ram chip socket and cleaned the chip pins. ... on the MPU and Driver on the bench until they boot and work reliably. ... I guess you have the IC version of the master display board from ... switch problems or shorts on the switch COL 4 of the switch matrix. ...
    (rec.games.pinball)
  • Re: TECH HELP: WPC-S Switch column 6 dead..Did all the usual fixes, no cure
    ... chip anyway and U13 also looked replaced, ... that socket out well while it was out. ... closing any switch on that column should cause the whole ... all the way back to the column 6 output on U20. ...
    (rec.games.pinball)
  • Re: Very unusual. Light causes circut to connect??????!!!!
    ... I don't know what or why it works, but I wired an IR diode in and volia. ... My theory on why it is working is that there is a crack in the chip on the ... >>to resolder or buy a new switch.. ... well sort of. ...
    (sci.electronics.repair)
  • Re: TECH HELP: WPC-S Switch column 6 dead..Did all the usual fixes, no cure
    ... chip anyway and U13 also looked replaced, ... that socket out well while it was out. ... closing any switch on that column should cause the whole ... all the way back to the column 6 output on U20. ...
    (rec.games.pinball)
  • Re: Mr. and Mrs pac help needed
    ... > of 10 times when the left one is hit the game resets always when you ... I noticed a mention of reset due to poor connection ... Possibly a switch matrix problem if it is always the left switch?? ... never removed a chip from a socket... ...
    (rec.games.pinball)