Re: i-cubed card stops boot after upgrade to 4.02
- From: druck <news@xxxxxxxxxxxxxxxx>
- Date: Wed, 14 Nov 2007 20:06:10 GMT
On 14 Nov 2007 "Paul B." <pnbunyan@xxxxxxxxx> wrote:
Just acquired a new sets of ROMs. Fitted them, but at power on I just
get a flash of red then a flash of green on the monitor and then
floppy seek, then back to flash of red then flash of green ad
infinitum. If I take the i-cubed card out it boots fine. If I re-fit
the 3.7 ROMs it boots fine and the card and can be configured. Refit
the 4.02 ROMs and get a boot failure again.
While using 3.7 check the versions of the modules on the card
(*ROMModules). It could be an old non RO4 compatible version, but
I've not heard of continual rebooting from that. It sounds more like
a hardware issue, but hardware issues wouldn't be affected by OS
version.
---druck
--
The ARM Club Free Software - http://www.armclub.org.uk/free/
The 32bit Conversions Page - http://www.quantumsoft.co.uk/druck/
.
- Follow-Ups:
- Re: i-cubed card stops boot after upgrade to 4.02
- From: Ray Dawson
- Re: i-cubed card stops boot after upgrade to 4.02
- References:
- i-cubed card stops boot after upgrade to 4.02
- From: Paul B.
- i-cubed card stops boot after upgrade to 4.02
- Prev by Date: Re: i-cubed card stops boot after upgrade to 4.02
- Next by Date: Re: i-cubed card stops boot after upgrade to 4.02
- Previous by thread: Re: i-cubed card stops boot after upgrade to 4.02
- Next by thread: Re: i-cubed card stops boot after upgrade to 4.02
- Index(es):
Relevant Pages
|