Re: PWM Signal

From: "Prashant Sandhi" <sanddhi7@xxxxxxxxx>
Date: Mon, 5 Oct 2009 14:16:03 +0000 (UTC)

Hi,
I am trying with pulse generator box but the output is not PWM.
Can you tell me the values I can set for the block.

"Arnaud Miege" <arnaud.miege@xxxxxxxxxxxxxxxxxxxxxx> wrote in message <hacs59$frf$1@xxxxxxxxxxxxxxxxxx>...

"Prashant Sandhi" <sanddhi7@xxxxxxxxx> wrote in message
news:hacql4$7a1$1@xxxxxxxxxxxxxxxxxxxxx

Hi,

I would like to know how can I generate a PWM signal in Simulink?
Duty cycle=90%
Amplitude = 5V
Frequency= 15KHz

use the pulse generator block
http://www.mathworks.com/access/helpdesk/help/toolbox/simulink/slref/pulsegenerator.html

HTH,

Arnaud

Follow-Ups:
- Re: PWM Signal
  - From: Sinem

References:
- PWM Signal
  - From: Prashant Sandhi
- Re: PWM Signal
  - From: Arnaud Miege

Prev by Date: Re: 2D Phase Unwrapping with Minimum Cost Flow
Next by Date: Re: Using Rand, min, max, mean, std, median, and hist
Previous by thread: Re: PWM Signal
Next by thread: Re: PWM Signal
Index(es):
- Date
- Thread

Relevant Pages

Using PCI CTR 05 board with xPC target
... I need to generate PWM signals by ... giving the duty cycle as the input. ... I get a PWM output only if I use duty ...
(comp.soft-sys.matlab)
Active PFC multiphase output question
... I am looking at a multiple boost converter active power factor correction circuit like below: ... My question is about the PWM controllers. ... My sampling rate is 100kHz so I make my adjustments to the duty cycle at 100kHz. ... PWM3 can be on from 6.666us to 10us ...
(sci.electronics.design)