Re: xPC Target TCP/IP Read error

"David Prévost" <plum117@xxxxxxxxxxx> wrote in message
<ef589cb.-1@xxxxxxxxxxxxxxxxxxxxxxx>...
Hi, we are building a 1553 system for scientific test. Is this
configuration we are using a host computer and a target PC
with xPC.
I?m using the demo model call xposc.mdl to test my
configuration.
After building and sending my model to xPC with the RTW
compilation (
tools->Real-time workshop->build model), I connect with
xpcExplorer to my targetPC. After a while, at a random
time and by
doing nothing, I got an error and then I get disconnected
from ma
target PC. After, I can reconnect with no problem but the
error
return after a random time. When I disable the refresh
(xpcexplorer
-> tools -> disable refresh) this error never appear. Also,
this error can occurs with any model that I choose.

I also use TCP/IP to connect to my xPC Target PC and this
also happens with me too. And sometimes it takes a few
tries to initially connect to the Target PC. It will fail a
few times saying it cannot connect but then finally does.
With RS-232, this was never a problem. Could it be because
of the router medium? Could I see better performance if I
used a crossover cable between my Host and Target,
eliminating a router? But then I lose remote access to my
xPC :(

Tommy
.

Relevant Pages

  • Re: xPC Target File I/O
    ... If you open up xpc Explorer and connect to your target, ... do you see anything under the 'File System' entry in the tree? ... 32MB FlashRAM disk. ...
    (comp.soft-sys.matlab)
  • Re: xPC Target test 5 FAILED
    ... But serial xpc communication is very ... so may be the "communication for commands" is not appropriatly ... industrial target computer through RS-232. ...
    (comp.soft-sys.matlab)
  • xpcbench problems
    ... I've recently started using Matlab R2008a (with xPC ver. ... have set up the correct configuration for the target PC I ... can ping the target PC via a DOS command prompt, ... timeout option in Simulation, Configuration Parameters, XPC ...
    (comp.soft-sys.matlab)
  • Ethercat in xPC target
    ... target as real-time OS for our controllers. ... This bus is a real-time extension of ethernet communication. ... master stack in the xPC real-time application. ...
    (comp.soft-sys.matlab)
  • Re: xpcbench problems
    ... On some target machines, compiling a new model and downloading ... it may or may not work without a reboot. ... and have run into a few problems regarding xPC. ... with microsoft visual studio .NET 2003 as my compiler. ...
    (comp.soft-sys.matlab)