Re: problem with mdlOutput in Simulink

Hi Ashish,

Thank you so much for your reply.
I am running in normal mode. So will it affected ?
My code now have 8 for loops that have to execute for 13
times each. If I just make it to execute for 3 times, the
value works fine(which I expected: nice output waveform). I
am not setting any discrete and continuous states as this is
purely power calculations.

I obtained my inputs for my S-function from 28 Discrete
fourier block(14 for each voltage and current) to obtain
voltage and current harmonic components. Then the value of
those discrete fourier block is used for power computations.
Is this the limitation of S-function that it couldn't
compute so many for loops ? Thank you so much for willing to
answer my questions.

Budi


.

Relevant Pages

  • Re: why is halting problem profound?
    ... answers (that is humans have come up with a solution (an algorithm ... ANY and ALL possible loops of code will ever end, unless you execute the ... 'The halting problem is unsolvable' is profound ...
    (sci.logic)
  • Re: problem with mdlOutput in Simulink
    ... I am running in normal mode. ... My code now have 8 for loops that have to execute for 13 ... I obtained my inputs for my S-function from 28 Discrete ...
    (comp.soft-sys.matlab)
  • Counter Intuitive Results: Optimising an FFT routine for Speed
    ... performed as necessary to match the variables data types. ... BTW - I could not get CYCLE.h to work, Turbo-C does not support ... FFT_NRC starting to execute 5000 loops ...
    (comp.lang.c)
  • Re: old Basic benchmark
    ... circa 1982 and 1983. ... As it stands it's not compatible with BASICs that execute FOR...NEXT ... loops at least once. ...
    (comp.lang.basic.misc)
  • Re: delay_tsc(): inefficient delay loop (2.6.16-mm1)
    ... if loops is 2^32-1, bclock is 1, the old version would execute the ... proper number of times, the new one will blow out in one tick. ...
    (Linux-Kernel)