Re: help on 10 wire stepper motor
- From: Gordon McComb <NOSPAMgort@xxxxxxxxxxxxxxxxxx>
- Date: Fri, 25 May 2007 12:40:48 -0700
zeb wrote:
I have a surplus stepper motor which I plan to use in robot project.
Unfortunately I have not been able to understand its wiring. (It has
10 wires coming out of it.). So I dared to open it up to look inside
so that it might clear the matter further. I have not had much success
after opening it either. There fore this request for help.
Because the plate says it's a four-phase stepper (rather than a five
phase stepper, and the pics seem to bear that out), then I'd surprimse
two of the wires are for some sense function. The other eight are
typical for a four-phase stepper where the wiring does not use commons.
-- Gordon
.
- References:
- help on 10 wire stepper motor
- From: zeb
- help on 10 wire stepper motor
- Prev by Date: Re: Gearmotors/Servos - Really basic question
- Next by Date: Re: Microcontroller options
- Previous by thread: Re: help on 10 wire stepper motor
- Next by thread: Re: help on 10 wire stepper motor
- Index(es):
Relevant Pages
|