Re: Gearmotors/Servos - Really basic question


"gareth" <garethrichardadams@xxxxxxxxx> wrote in message
news:1179916409.453953.56350@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
Hi,

If I get a servo and remove everything form inside it except the motor
and the gears will it work as a gearmotor??

If so, can anyone recommend a really cheap servo I can use as a gear
motor, preferably one that has matching servo wheels...

Thanks

gareth

Yes, but you may need to remove the moulded "stop" on the final gear to get
360 degree rotation.

Deep.


.

Relevant Pages

  • Re: CNC software highest step rate
    ... The problem with simply disabling the amp when approaching a limit is ... that the motor will then coast. ... > amp and get a steady speed from the servo motor is why resonance is not ... > a problem at high speeds with servo motors used as intended. ...
    (rec.crafts.metalworking)
  • Re: Anyone ever taken apart a Black Hole spinner motor assembly?
    ... different motor mounted in backbox but without the gear box. ... I touched the leads to the oem motor, ... The shaft in the gear box was bent and had a lot of play. ... The gearmotor assembly bolted right up, ...
    (rec.games.pinball)
  • Re: Access to Wiper Motor 91 SL
    ... I removed the cover to the wiper motor worm gear. ... The grease is fairly hard to the touch. ...
    (alt.auto.mercedes)
  • Re: Homemade CNC 2 spindle lathe question
    ... Note that a servo motor *can* run at a very stable speed, ... controlled by a true servo amplifier and with tach generator feedback. ... the headstock spindle generating the command voltage to the true servo ... so it has a very wide range of precise speeds. ...
    (rec.crafts.metalworking)
  • Re: EM tech advice: Gottlieb score motor gears
    ... I made the same repair to the score motor for a Gottlieb 300 a few ... I bought the fiber gear from PBR and it worked fine. ... rivets drilled out. ... tapped the frame and used appropriately sized machine screws. ...
    (rec.games.pinball)