Bluetooth link to replace serial cable for OOPic

Hi,

I have an oopic II+ microcontroller with RS232 level converters and I
am currently programming it with a serial cable connected to my PCs
COM1 port. I want to replace the serial cable with a Bluetooth link to
allow wireless dat transmission between the PC and the robot as it
executes my program.

I have the HPU-100 USB Bluetooth dongle and HPS-120 RS232 transceiver
from Total Robots (http://www.totalrobots.com/access_files/wcm.htm).
However, I cannot get the two to communicate. I have the HPS-120
connected to the DB9 connector of the RS232 converter board, and it is
receiving power etc ok. I have installed all the drivers for the USB
dongle, but it always shows up that it can't find any bluetooth
devices. It does show up in device manager that I have the drivers
correctly installed so that should not be the problem.

Has anyone used these modules (or similar) before and can tell me if
I'm missing something obvious?

Thanks,
Niamh

.

Relevant Pages

  • Re: How do you change a bad CD-Rom Drive?
    ... (IDE, power). ... If the old drive had an analog audio connector and ... the connector is the same, ... You may need to go into Device Manager ...
    (microsoft.public.windowsxp.general)
  • Re: Detecting "real" formula in a cell - why I want to do it
    ... There are programming alternatives that avoid VBA. ... >I was hoping to avoid doing programming beyond shapesheet formulas. ... > see the connector visual clues only when the connector shape is selected. ...
    (microsoft.public.visio.developer)
  • Re: network failure..
    ... >> I suspect that the Ethernet cable, connector, or crossover cable has ... Can you move the computers close enough together to ... >reboot, still no go. ... Un-install the NIC in Device Manager. ...
    (microsoft.public.windowsxp.general)
  • Re: JTAG pogo-pin connector
    ... I've been using typical headers that match the connector on the ... I've used this samtec one-piece once for programming. ... The UUT had the pads, and the programming fixture had the connector. ...
    (sci.electronics.design)
  • Re: Weird BK problem
    ... a 4 pin connector IJ4/IP4. ... Also the credit button is on the switch matrix, as well as the tilt. ... start a new game or make changes in programming the machine. ... numbers scroll through 1-50 non stop so I cant select the right number ...
    (rec.games.pinball)