Re: Scanner Software -- long, referring to Epson

What is the expected distance between the glass (below the film) and the
film when a holder is used? <<

Ideal is supposed to be 3 mm but often is not, so that is why the ability to
adjust is important. Epson provide some snap in tabs that will give you two
other height options (2.5 mm and 3.5 mm if I remember right).

Doug
--
www.BetterScanning.com - Custom Film Holders and Accessories for Agfa,
Microtek and Epson Scanners


.

Relevant Pages

  • Re: 35 mm slides
    ... 35mm slide holder uses perforation and cannot scan rolls... ... I can't cut the film, ... toilet roll works fine) on the other side, and gently pull the film through ... Hp haven't made or sold this scanner for some years, sadly, so the second ...
    (soc.genealogy.computing)
  • Re: Scanning old film
    ... I'm not sure about the dimensions of 125 film, but I have used a Canon ... flatbed scanner to scan 110 format film. ... edge of the holder for 120 film, and then scanning it as a color positive. ...
    (rec.photo.digital)
  • Re: film options for SEM
    ... >>bulk sheet film. ... The 6x12cm frames produced ... I was talking about the Polaroid 545 back, not a Graflok holder. ...
    (sci.techniques.microscopy)
  • Re: Red Edge from Nikon 5000 ED Scanner
    ... where there may be source light reflecting off of the holder onto the film? ... the film strip holder provided. ... But I don't think you analyzed the frame edge question above very carefully. ...
    (rec.photo.equipment.35mm)
  • Re: My Epson 3170
    ... actually want as part of the file (definitely don't include andy of the holder or gaps between the film and holder if there are any). ... If that still doesn't work, turn the auto exposure off and manually set your expsure. ... I was looking at your film holder and I think I figured out my problem. ... I was trying to scan from an uncut roll of negatives, and the extra film was draped over the calibration window in the back. ...
    (comp.periphs.scanners)