Re: Canon BJ30 problem

Tony wrote:
skiingmonk@xxxxxxxxxxxx wrote:
I bought a second hand Canon BJ30 printer but the ONLINE light keeps
blinking and nothing prints. None of the butons works except the Power
button. I have put a brand new cartridge in but it hasn't made a
difference. Any help is appreciated.

Please ignore the idiot response from our newsgroup troll, he has no idea of
the value of this printer. You and I do however, these portables were very
expensive to buy and are well worth looking after.
Do you get either any beeping sounds or a message on the display? Also does the
online light blink continuously or does it pause and then start to blink again?
If there is a pause can you count the number of blinks between pauses. If you
get any beeps how many times does it beep or do you get a long beep (about 3
seconds)?
Tony

Most of the time when I turn it on, (1) The online light begins
flashing at a constant rate about 3 times per second. After 5 minutes,
there are 2 beeps and the online light stops flashing but I get either
Code E6 or Code E13. (2) Once, I turned it on and there was some kind
of count down on the numerical panel and I got a Code E13 (no flashing
online light),

I am 100% sure I have put the catridge in correctly and it was a brand
new sealed one anyway.

.

Relevant Pages

  • Re: Canon BJ30 problem
    ... get any beeps how many times does it beep or do you get a long beep (about 3 ... Most of the time when I turn it on, The online light begins ... I am 100% sure I have put the catridge in correctly and it was a brand ... E6 means BJ Cartridge not installed correctly. ...
    (comp.periphs.printers)
  • Re: Time Standard Dilemma
    ... station "beeps" on the hour almost exactly. ... beep because they use a delay to seamlessly remove coughing. ... I just checked the clock and it has no brand name. ...
    (sci.electronics.design)
  • Re: when booting up system keeps beeping and dont start up
    ... You told me how many beeps, ... "thecreator" wrote: ... What is the Brand Name and Model Number of the Computer, ... pattern over and over without starting up. ...
    (microsoft.public.windowsxp.help_and_support)
  • Re: when booting up system keeps beeping and dont start up
    ... It is an error code but without knowing the exact number of beeps in a pattern, it is hard to point you in a direction. ... What is the Brand Name and Model Number of the Computer, and if custom-built, the Motherboard's Manufacturer, Brand and Model Number of the board? ...
    (microsoft.public.windowsxp.help_and_support)