Re: Printing CDs on Epson R1800 using Avery AfterBurner
- From: "Caitlin" <caitlin_online_nospam@xxxxxxxxxxx>
- Date: Tue, 2 Aug 2005 19:16:09 +1000
"ftran999" <ftran999@xxxxxxxxxxx> wrote in message
news:0ISdnTqYYKyZIHPfRVn-pA@xxxxxxxxxxxxxx
>I designed a CD label using Avery's AfterBurner CD label printing software.
>I placed a blank label over a blank CD(since I don't have the special
>printable CDs) and loaded it into the CD tray and placed it into the
>printer. Under the paper options for source I chose CD/DVD, the type of
>paper was matte, and the only choice in size allowed was A4. After the
>printing was done the designed was off center, skued to the right. I
>consulted my printer manual and followed the instructions under adjusting
>print position. However, the target was dead center and did not need any
>adjusting. I then consulted the help topics in AfterBurner and it
>suggested calibrating the printer. Unfortunately this only seems to work
>if the source is the sheet feeder and not the CD/DVD tray. I should point
>out that I have no problems printing using the sheet feeding method. The
>printer did come with Epson's own CD printing software but I like Avery's
>software better.
> Any suggestions would be greatly appreciated.
> Thanks in advance.
Sounds like Avery Afterburner isn;t designed to printing direct to CD, but
only to labels. Check their website and make sure there isn't an update.
.
- References:
- Printing CDs on Epson R1800 using Avery AfterBurner
- From: ftran999
- Printing CDs on Epson R1800 using Avery AfterBurner
- Prev by Date: Re: HP4 black pages
- Next by Date: Re: best place for cheap cables?
- Previous by thread: Re: Printing CDs on Epson R1800 using Avery AfterBurner
- Next by thread: best place for cheap cables?
- Index(es):
Relevant Pages
|
