VME backplane bus connector cleaning!

HI guys,

Did you guys have any experience to clean the VME backplane bus
connectors? We have a ELMA backplane with 21 slots. We have been using
it for 5 years and it results in very dirty with oil from hands
(touched the connector side of cards and oil got sticked onto the
backplane i guess) and dust from air. We can use canned compressed air
to clean the dust, but how to clean oil from those tiny holes on the
bus connector?

Thanks in advance
Ray

.

Relevant Pages

  • Re: VME backplane bus connector cleaning!
    ... Isopropyl alcohol should dissolved the oil. ... Did you guys have any experience to clean the VME backplane bus ... We have a ELMA backplane with 21 slots. ... (touched the connector side of cards and oil got sticked onto the ...
    (comp.os.vxworks)
  • Re: cleaning NES cartridges?
    ... that should clean it off also. ... >HI Corey, Thanks! ... I took a couple of carts apart again and wiped them ... >might have been transfered from the carts to the 72 pin connector. ...
    (rec.games.video.nintendo)
  • Re: Intermittent drivability problem due to fretting corrosion -- a case study
    ... Yet another problem fixed by Deoxit D5. ... I have been using it to clean ANY connector I ... remove, no matter how shiny, before returning to service. ...
    (rec.autos.tech)
  • Re: PS2/70 BOOT PROBLEM WITH MOUSE
    ... Examine and clean up the mouse port on the back of the system case ... Clean the system board and power supply with compressed air. ... Or, the mouse port connector ... say) to acquire a suitable repalcement PS/2 machine either from a member ...
    (comp.sys.ibm.ps2.hardware)
  • Re: how to replace the cartridge connector?
    ... spray some inside the connector. ... where the cartridge would insert. ... Clean the cartridges as normal also, as they might transfer stuff back ... I was searching for a replacement part for the Sega Genesis ...
    (rec.games.video.sega)