Re: configurations and generics

Andy Luotto wrote:

and i would like to design configurations of the same test bench with
different generics, something like

I know this isn't any help, but good luck with that! I struggled with
getting configurations to do anything *useful* (in a concise manner) for
me and gave up after a couple of days... :(

Regards,

--
Mark McDougall, Engineer
Virtual Logic Pty Ltd, <http://www.vl.com.au>
21-25 King St, Rockdale, 2216
Ph: +612-9599-3255 Fax: +612-9599-3266
.

Relevant Pages

  • Re: Generics vs Constants - what criteria do you use to choose between these?
    ... constants/lower level generics. ... On the subject of design reuse, say I'm reusing a module in an upgrade ... There are many reasons to have different configurations for simulation ...
    (comp.lang.vhdl)
  • Re: Defining Stimulus type and encapsulating parameters
    ... I use these for dynamic controls and make them signals. ... switching between different configurations. ... I like the initialized generics approach and use this frequently. ... default binding (most recently compiled architecture). ...
    (comp.lang.vhdl)
  • Re: Using default value of a generic in VHDL
    ... Like Mike, I tend to customize via top level generics specified via ... I still use configurations in some testbenches, ... from the vsim command line to cover special cases. ...
    (comp.lang.vhdl)
  • Re: configuration of generic - again?
    ... Is there a specific reason for not allowing to set generics of the ... So i put a generic in the testbench entity declaration. ... But I would still like to simulate on my configurations, ...
    (comp.lang.vhdl)
  • Re: Complex Casting problem in Generics
    ... googling but to no luck so far). ... Can I overload the cast operator and do this? ... internalProfile casts to BASEPROF ... Are you absolutely sure you need generics here in the first place? ...
    (microsoft.public.dotnet.languages.csharp)
Loading