Re: something to stabilaze the signal

Hi Boris,


Since you are using the DAQ Assistant,
the easiest way to software trigger your signal will be using the Trigger and
Gate Express VI. I?ve attached an example VI below using this. It?s set to
trigger on the rising edge with 500 pre and post trigger samples. Another great
example of software trigger at a lower level is the DAQmx example, Cont
Acq&Graph Voltage ? Analog SW Trigger.vi. This example can be found in the
NI Example Finder. To get to it in LabVIEW go to Help >> Find Examples?
>> Hardware Input and Output >> DAQmx >> Analog Measurements
>> Voltage >> Cont Acq&Graph Voltage ? Analog SW Trigger.vi.


Let me know if you have any questions and
take care.


Thanks,


Trigger and Gate Example.vi:
http://forums.ni.com/attachments/ni/170/327837/1/Trigger and Gate Example.vi
.

Relevant Pages

  • Re: watering system, second attempt.
    ... It gives a good solid pullup to drive the gate cap. ... trigger on either a rising or falling edge, ... html mail or attachments will go in the spam ...
    (sci.electronics.basics)
  • Re: What would you call this?
    ... equivalant of an SCR out of transistors, ... SCRs that will trigger well below 1 mA. ... experiment with making your own from transistors. ... I didnt say that the 2n5060 needs 20mA gate trigger .What I said is ...
    (sci.electronics.basics)
  • Re: TECH - escalating MM problems
    ... triggered in sequence in order for the gate to open. ... then the upper switch immediately to see if the gate opens (you'll ... to trigger each of them. ... These are common trouble switches. ...
    (rec.games.pinball)
  • Re: TECH - escalating MM problems
    ... There are two switches on each loop that must be ... triggered in sequence in order for the gate to open. ... then the upper switch immediately to see if the gate opens (you'll ... to trigger each of them. ...
    (rec.games.pinball)
  • Re: What would you call this?
    ... The thing about an SCR is it needs an intiateing current even the ... Gate current is no problem, ... You can get sensitive gate ... SCRs that will trigger well below 1 mA. ...
    (sci.electronics.basics)