Re: Immediate Load Config

Hi JJlee
ran your config vi-it appears to be functional.
One pt: you will helpself if you use a standard terminal configuration ie 4 inputs + 4 outputs
This makes it easier to align vi's. Also you can add auxilary
input/outputs between the Left hand side (input) and the Right Hand
side (Outputs)
ie top edge and bottom edge which will not affect the vin layout.Where
as adding extra terminal on LHS and RHS  cause cosmetic 
deviants:smileymad:
If you reread NI guide lines they recommend no more than 12 (maybe 16) terminal max per Vi  :smileywink:

Checked you Main Vi 'Pulse Channel with Load and Save_no event _v09.4
In the Run state - True frame:
In the initialisation of HP8133 you query and reset Instrument !!
Personally I would check the connection to instruments before loading
config data.Your reset commands reinitialises instrument to default
state. I suspect this is where you have a problem !
It take inifinite time for instrument to execute command But at same time you are firing off other commands.
(Attempting to load config parameters)
Suggest you either disable instrument reset or allow ~5 sec wait state before proceeding.

Using NI spy should highlight this problem !

Regards
xseadog
.

Relevant Pages

  • Thoughts on PIX v7 cont...
    ... few commands did not "port" over properly. ... -Since we have a FO config - turn off SECONDARY and upgrade the ... turn off the PRIMARY and upgrade the SECONDARY. ... PIX config is 4800 lines long, so it was only about 2%. ...
    (comp.dcom.sys.cisco)
  • Re: Netgear PS101 Print Server Setup with Fedora...
    ... > server but I do not know which options to set or choose to set up the ... here's my notes (recall there is a reset button on the box, ... edit CONFIG <- edit the IP,NM,GW etc.etc. ... ncftp /> ls ...
    (Fedora)
  • Vlans on a 2900 series XL switch
    ... I have a 2900 series XL switch I bought in a bundle for my home lab to ... set up vlans on this device would be greatly appreciated. ... back to the config menu, I was going to try and set up a vlan domain ... using them commands but now I can not get into the config menu either. ...
    (comp.dcom.sys.cisco)
  • Re: difficulty recompiling RHEL 4.2 kernel
    ... After installing the kernel source you need to do; ... with the default config files in an appropriate subdirectory. ... and 'make install' commands you can use the 'make rpm' command. ...
    (comp.os.linux.setup)
  • Re: looking for a LabVIEW interface for controlling a material test stand
    ... Attached are some vis for communicating with an Instron ... These vis do basic things like send commands and read ... commands are correct for your instrument. ...
    (comp.lang.labview)