Channel Vision whole house DSL filter

I bought one of these for the new DSL connection, but I've got a couple of
issues.

1) How does one wire up the RJ31 jack? i.e. what wire goes where?

I've got an ITI Simon alarm that seems to have four power wires and two
phone wires going back to the alarm panel. I gather I just need to wire up
the red/green to the center of the RJ31 connector.

2) There is still static on the phone line, even with the filter installed.
Modem seems to work OK, so I'm not sure if the filter sucks or I have a
connection issue.



.

Relevant Pages

  • Re: Hum, Ground Loops and Safety
    ... conductor path to a place where there's a lower charge. ... grounding wire. ... unintentional connection between the hot wire and the chassis of the amp. ... there will be a fuse or circuit breaker wired into the hot ...
    (alt.guitar.bass)
  • Re: Best wire crimper
    ... The wire used in the connector isn't too small. ... Pull to test the integrity of the connection, ... And -- the insulation grip part is crimped with a section more like this ... And of course -- this is only barrel style terminals. ...
    (rec.crafts.metalworking)
  • Re: 230V to 110VAC isolation transformer
    ... and the earth wire. ... the neutral connection at the power point is connected to ... BUT IT IS ESSENTIAL FOR THE METAL CASING OF THE AMP TO BE CONNECTED TO ...
    (rec.audio.tubes)
  • Re: Wierd Ground Problem?
    ... the cable incoming from dish must make a connection to ... utility wire. ... This 'single point earth ground' is required by ... cables to the same dish, now we have a ground loop. ...
    (sci.electronics.misc)
  • Re: Need help... End-fed, long wire or ????
    ... To answer this and your other question about radials, ... I drove a ground rod at a remote point, about 12 feet from the house ... The sky wire merely lifted off from about 1 foot off the ... connection and broke the coax connection there. ...
    (rec.radio.amateur.antenna)