Re: X10 General Question

Okay. Thanks. I am having trouble setting the code on the Rocket Socket
though (it doesn't have a dial). It says:

Plug the lamp (with the socket rocket installed) into the same outlet
as the transceiver. Does this mean plug it into the outlet ON the
transceiver or in the same electrical box as the transceiver?

It then says to (within 30 seconds) press the ON button 3 times, about
1 second intervals. There is a comment that each press corresponds to
the unit code. So for code 3, do I press 9 times (pausing after each 3
presses)? It says it will turn the lamp on to confirm, but isn't
doing that and it isn't turning on via motion detected (and I verifeid
that is set to code 3). Everything is set to the same house code.

..

.

Relevant Pages

  • Re: X10 with ungrounded Shop Light...Bad idea?
    ... The shop light has a 3 prong plug, but the Transceiver only has a 2 ... Normally, if a lamp, say is off, and you ...
    (alt.home.repair)
  • Re: X10 with ungrounded Shop Light...Bad idea?
    ... The shop light has a 3 prong plug, but the Transceiver only has a 2 ... Normally, if a lamp, say is off, and you ...
    (alt.home.repair)
  • Re: New question.
    ... Npw what about the fact that when i have my lamp plugged in? ... radio does not work. ... It only happens when i plug something in to the 12 ... adapter in my boat it dosnt work, also my UHF radio will not work ...
    (rec.boats)
  • Re: FS: All manner of Acorn Hardware
    ... insulatorbut are a bit of a danger to probing fingers. ... when changing a lamp. ... simply using a 15 to 13A tail to plug it into a wall socket. ... techie when it comes to checking my lanterns. ...
    (comp.sys.acorn.hardware)