Re: Best error control code for 200 bit msg with 60 errors

From: Vladimir Vassilevsky <antispam_bogus@xxxxxxxxxxx>
Date: Tue, 29 Jul 2008 09:02:59 -0500

Faisal wrote:

I want to send messages of 200 bits with 60 possible errors. Which
error correcting code should I use that gives the highest rate for
these parameters.

It depends.

Vladimir Vassilevsky
DSP and Mixed Signal Design Consultant
http://www.abvolt.com
.

References:
- Best error control code for 200 bit msg with 60 errors
  - From: Faisal

Prev by Date: assemble 2K FFT by 2 times 1K FFT?
Next by Date: Re: basic speech analysis: amplitude, phase, intensity
Previous by thread: Best error control code for 200 bit msg with 60 errors
Next by thread: Re: Best error control code for 200 bit msg with 60 errors
Index(es):
- Date
- Thread

Relevant Pages

Re: firmware
... Vladimir Vassilevsky ... DSP and Mixed Signal Design Consultant ...
(comp.arch.embedded)
Re: Best way to get 2.5 volts from somewhere? (Vcc = 5 volts)
... Vladimir Vassilevsky ... DSP and Mixed Signal Design Consultant ...
(comp.arch.embedded)
Re: accessing memory addresses using C
... Vladimir Vassilevsky ... DSP and Mixed Signal Design Consultant ...
(comp.dsp)
Re: How to find why the system reset?
... Vladimir Vassilevsky ... DSP and Mixed Signal Design Consultant ...
(comp.arch.embedded)
Re: BlackFin as a controller
... Vladimir Vassilevsky ... DSP and Mixed Signal Design Consultant ...
(comp.arch.embedded)