Re: ti's EZ-DSP STARTER KIT FOR F2812 -> just the board

On May 30, 10:25 am, Vladimir Vassilevsky <antispam_bo...@xxxxxxxxxxx>
wrote:
cs_post...@xxxxxxxxxxx wrote:

This is a dead end. Trying to make a sellable product as a pile of
evaluation boards, reference designs and the googled opensource junk
reflects the insufficient resources and the general lack of talent and
experience.

If you are headed for high volume production, then you need an
optimized solution. If you are making 5-10 of something
(and there are high value, fast schedule orders like that out there),
then you need something that is fully capable of doing
the job, and you need to spend your time writing software and telling
the techs how to connect the wiring harnesses, not shepherding a board
layout and waiting on a board house. Yes, you can get a new board in
your hands from concept inside a week, but it's often a stressful week
that you really need to spend working on something else. And half
that time, the area around the micro/DSP is a cut and paste from the
reference design anyway. So if there's something suitable available -
especially if it's something you already manufacture - then it's often
good to use that rather than start over.
.