f240_hex.exe ERROR: Unable to open fastdrive.out

Hi,

I'm trying to convert a file to obtain a .hex file (myfile.out to
myfile.hex) using f240_hex.exe provided by TI.

Unfortunately, I always get this error message :

"ERROR: Unable to open myfile.out
Conversion aborted"

myfile.out is obtained by compiling my project with Code Composer
Studio (version 2.20).

In Build options, Linker, Advanced, the COF output format selected is
COFF1 (as recommended in TI's documentation).

When I convert example provided with the tool, it works well.

Any idea ?

.

Relevant Pages

  • Re: static and dynamic linking
    ... operating system is mandrake linux 32bit, ... after looking at the command and the error message ... then the linker is ignoring it for that reason. ... then there's an installation problem for either ...
    (comp.lang.fortran)
  • Re: f240_hex.exe ERROR: Unable to open fastdrive.out
    ... I always get this error message: ... In Build options, Linker, Advanced, the COF output format selected is ... could be a path problem. ... Or perhaps, if this is a command line tool, you need to ...
    (comp.dsp)
  • RE: unresolved token!!!
    ... now the question is: The error message of linker in VS.NET ... This is a known issue of VS.NET linker. ... will give better diagnostics. ... Thanks very much for your feedback, ...
    (microsoft.public.dotnet.languages.vc)
  • Re: Linker question: thread_safe and no_exceptions
    ... UNIX linker. ... We have no idea where this error message came from. ... It's not in the linker nor is it in the C, C++, F77 or F90 drivers. ... Is Compaq's online documentation ...
    (comp.unix.tru64)
  • Re: Need advice
    ... I find nothing specific to that application and error message; ... But then the Linker still would not run. ... uninstalled MS VC Pro ver 6.x, rebooted and then tried to install it ... "Setup has encountered and error and cannot continue" setup then exits. ...
    (microsoft.public.windowsxp.help_and_support)