Re: Help required - tms320c6713

<tuurbo46@xxxxxxxxxxx> wrote in message
news:1141078829.494830.292470@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx

Howard

I have ccs 2.2. I belive this may be the problem. I have copied all
folders from chassaing cd into my project folder. Would this cause an
error?

when i install project i do the following

# open CCS
# add new project - grapicalEQ
# rebuild all
# load program
# load gel
# run
# then bring gells onto form
# at this point the music is playing, but when the gels are moving the
error occurs.

Do you load up this way?


Yes. I did use CCS2.21 (the DSK version) a few months back and I'm pretty
sure all those demos worked, as I was learning myself of that platform.
Don't think I have a setup I'd care to install this version onto again
though - my systems are at 3.1 now.

Howard


.

Relevant Pages

  • Re: Help required - tms320c6713
    ... I have ccs 2.2. ... folders from chassaing cd into my project folder. ... # load program ...
    (comp.dsp)
  • Re: Equivalent active device circuit for CT choke.
    ... Cathode CCS is the one I normally use but any CCS will work. ... It works like you'd expect from a CCS plate load. ... so 0.2% at 2Vrms from the pentode becomes 0.002%, ... and where you supply a fixed bias to the top triode ...
    (rec.audio.tubes)
  • Re: Equivalent active device circuit for CT choke.
    ... With a CCS cathode sink and choke and some series R ... dynamically then the circuit should balance very well. ... much higher load ...
    (rec.audio.tubes)
  • Re: SRPP
    ... with a single common cathode stage triode such as ... The output from the gain pot is fed to a normal ... The CF has a mje 340 as a CCS load to sink the dc from ...
    (rec.audio.tubes)
  • Re: SRPP
    ... with a single common cathode stage triode such as ... The output from the gain pot is fed to a normal ... The CF has a mje 340 as a CCS load to sink the dc from ...
    (rec.audio.tubes)