Re: help ...!!!


"Hash" <coolmessage@xxxxxxxxx> wrote in message
news:1135753931.299697.281380@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
> well tim i have a project about heartbeat monitoring system and i have
> to calculate dat how much frequency i can measure from external source
> maximum frequency and how would be the minimum frequency i would able
> to measure .. well it was not part of the project but i was forced to
> calculate all this can ya help me with this i will be very thankful to
> ya ..
>
> if any other information ya required i am here :((
>
O.K., I'm assuming that you have a board with a microprocessor on it which
is compatble with the 8051 instruction set : does this particular chip have
an inbuilt ADC? if not what are you using and how is it clocked? : what
data storage do you have on the board? can you provide the type of
microcontroller/processor you are actually using? 8051 is a bit too generic.
After that someone who actually knows something about DSP might be able to
help ( I hope).

Best of Luck - Mike


.